Toshiba e-STUDIO556 - Drum Surface Potential Sensor (S13)

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 58
4.6.4 Drum surface potential sensor (S13)
(1) Take off the cleaner unit.
( P.4-61 "4.7.1 Cleaner unit")
(2) Disconnect 1 connector, remove 1 screw,
and then take off the sensor bracket.
Fig. 4-164
(3) Disconnect 1 connector, remove 1 screw,
and then take off the surface potential sensor
(detection section).
Fig. 4-165
(4) Disconnect 1 connector, release 4 lock
supports, and then take off the surface
potential sensor (board section).
Note:
The drum surface potential sensor consists
of the detection section and the board
section as a set.
Fig. 4-166
Sensor bracket
Screw
Connector
Screw
Drum surface potential sensor
(
board section
)
Locking support
Locking support
Drum surface potential sensor
(
detection section
)