Toshiba e-STUDIO556 - Toner Cartridge Drive Unit

4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 69
4.8 Developer Unit
4.8.1 Toner cartridge drive unit
4.8.2 Toner cartridge switch (SW2)
(1) Take off the right front inner cover.
( P.4-1 "4.1.2 Front right inner cover")
(2) Disconnect 1 connector.
(3) Loosen 1 screw to take off the bracket.
(4) Pull down the fixing pin and rotate it by 90º.
Fig. 4-194
(5) Pull out the toner cartridge drive unit up to
approx. 30º, and then take it off in the
direction of the arrow.
Fig. 4-195
(1) Disconnect 2 connectors, remove 1 screw,
and then take off the toner cartridge switch
with the bracket.
(2) Remove 2 screws to take off the toner
cartridge switch.
Fig. 4-196
Fixing pin
BracketScrew
Toner cartridge drive unit
Top cover
Toner cartridge detection switch
Screw
Screw