Toshiba e-STUDIO556 - Feed Driving Unit

4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 45
4.5.6 Feed driving unit
(4) Take off the tray-up motor.
Note:
Align the boss of the gear and the hole of the
cover when installing the tray-up motor.
Fig. 4-127
(1) Take off the switching regulator.
( P.9-6 "9.1.8 Switching regulator (PS)")
(2) Take off the feed motor.
( P.4-44 "4.5.4 Feed motor (M20)")
(3) Disconnect 1 connector and remove 5
screws to take off the AC input.
Fig. 4-128
(4) Release the harness from the clamp and
remove 6 screws to take off the feed driving
unit.
Fig. 4-129
Tray-up motor
Boss
Boss
AC inlet
Screw
Screw
Screw
Connector
Feed drive unit
Screw
Screw
Screw