Toshiba e-STUDIO556 - Original Pickup Solenoid (SOLR1)

4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 145
4.12.31 Original pickup solenoid (SOLR1)
(1) Take off the RADF rear cover.
( P.4-117 "4.12.3 RADF rear cover")
(2) Disconnect 1 connector.
(3) Remove 2 screws and take off the original
pickup solenoid.
Fig. 4-411
(4) Remove 2 screws and take off the bracket
from the original pickup solenoid.
Fig. 4-412
Note:
When installing the solenoid, check if it is
aligned with the position indicated in the
figure. (The scale is longer in the center.).
Fig. 4-413