Toshiba e-STUDIO556 - Original Width Detection Sensor-3 (SR8)

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 152
4.12.40 Original width detection sensor-3 (SR8)
4.12.41 Original width detection sensor-2 (SR7)
(3) Remove 4 screws and take off the feeder
lower guide unit.
Fig. 4-432
(1) Take off the feeder lower guide unit.
( P.4-151 "4.12.39 Feeder lower guide
unit")
(2) Disconnect 1 connector. Lift the actuator,
release 2 latches and take off the original
width detection sensor-3.
Fig. 4-433
(1) Take off the feeder lower guide unit.
( P.4-151 "4.12.39 Feeder lower guide
unit")
(2) Disconnect 1 connector. Lift the actuator,
release 2 latches and take off the original
width detection sensor-2.
Fig. 4-434
Original width detection sensor-3
Original width detection sensor-2