e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
6 - 16
6.3.4 Scanner related adjustment
Make a copy, compare the result with the original and make an adjustment if the image is distorted.
[A] Image distortion
Fig. 6-14
<Procedure>
(1) While pressing [0] and [5] simultaneously,
turn the power ON.
(2) Press [FAX] next [START] to make a copy of
any image on a sheet of A3/LD paper.
(3) Key in [3033] and press the [START] button
to move the carriage to the adjustment
position.
(4) Remove the original glass.
(5) Make an adjustment in the order of step 1
and 2.
•Step 1
- In case of A:
Tighten the mirror-3 adjustment screw
(CW).
- In case of B:
Loosen the mirror-3 adjustment screw
(CCW).
•Step 2
- In case of C:
Tighten the mirror-1 adjustment screw
(CW).
- In case of D:
Loosen the mirror-1 adjustment screw
(CCW).
Fig. 6-15
Fig. 6-16
Feeding direction
Feeding direction
Step 1
A
Step 2
C
B
D
Adjustment screw for the mirror-3
Carriage-2
Carriage-1
Adjustment screw for the mirror-1
To Next Page
Loading...
