4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 37
[ 2 ] Transport motor (M17)
[ 3 ] Transport roller
(4) Disconnect 2 board connectors and release
4 lock supports to take off the board.
Fig. 4-104
(1) Disconnect 1 connector.
(2) Remove 2 screws to take off the motor.
Fig. 4-105
(1) Remove 1 E-ring to pull out the bearing from
the shaft.
(2) Remove the pin of the pulley by moving the
shaft toward the motor. Then remove the
pulley and bearing to take off the transport
roller with its shaft.
Fig. 4-106
Motor driving PC board
Transport motor
Belt
Bearing
Bearing
Pulley
Pin
To Next Page
Loading...
