Toshiba e-STUDIO556 - Page 181

4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 35
[ 6 ] Drawer detection sensor (S29/S35/S41/S47)
[ 7 ] Drawer feed sensor (S34/S40/S46/S52)
[ 8 ] Drawer bottom sensor (S30, S37, S42, S48)
(1) Disconnect 1 connector to take off the
drawer detection sensor.
Fig. 4-98
(1) Remove 1 screw to take off the drawer feed
sensor with its bracket.
(2) Disconnect 1 connector to take off the
drawer feed sensor.
Fig. 4-99
(1) Take off all the feed units.
( P.4-31 "4.5.1 Paper feeder unit / Bypass
feed unit")
(2) Disconnect the connector and take off each
drawer bottom sensor.
Note:
Equipment with the LCF does not have the
3rd and 4th drawer bottom sensors.
Fig. 4-100
Drawer detection sensor
Drawer feed sensor
Drawer
bottom sensor