e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 40
[E091]Other time-out jam
[E0A0]Image transport ready time-out jam
Classification Error item
Other paper jam The equipment does not operate normally because abnormality occurred
on an interface between the SYS board and engine firmware.
Check item Measures
Other • Remove the paper remained in front of the registration sensor.
• If the error still occurs, check the following.
Power • Check if the error is cleared by turning the power OFF and then back
ON.
SYS board • Connector check
• Page memory check
• Board check.
LGC board • Connector check
• Harness check.
• Board check.
PLG board • Connector check
• Harness check.
• Board check.
HDD
• Harness check.
Replace parts Remarks
Page memory
HDD
SYS board
LGC board
PLG board
Classification Error item
Other paper jam Image data to be printed cannot be sent.
Check item Measures
Other • Remove the paper remained in front of the registration sensor.
• If the error still occurs, check the following.
Power • Check if the error is cleared by turning the power OFF and then back
ON.
SYS board • Connector check
• Page memory check
• Board check.
LGC board • Connector check
• Harness check.
• Board check.
HDD
• Harness check.
To Next Page
Loading...
