e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 38
Relation between the jamming area and the corresponding sensors and covers
[E061] Incorrect paper size setting for 1st drawer
[E062] Incorrect paper size setting for 2nd drawer
[E063] Incorrect paper size setting for 3rd drawer
[E064] Incorrect paper size setting for 4th drawer
Each sensor • Sensor check (Refer to the following table.)
• Connector check
• Harness check.
LGC board • Connector check
• Board check.
Drive unit, Rollers • Gear check
• Roller check
Jamming area Sensor Test mode / Input check
Registration area Registration sensor 03-[FAX]ON/[4]/[E]
Exit/Reverse area Exit sensor 03-[FAX]OFF/[7]/[B]
Reverse sensor-1 03-[FAX]OFF/[7]/[E]
Reverse sensor-2 03-[FAX]OFF/[7]/[D]
Fuser transport sensor 03-[FAX]OFF/[7]/[C]
Reverse transport area Horizontal transport sensor-1 03-[FAX]OFF/[9]/[F]
Horizontal transport sensor-2 03-[FAX]OFF/[9]/[G]
Horizontal transport sensor-3 03-[FAX]OFF/[9]/[H]
Paper feeding area 1st drawer feed sensor 03-[FAX]OFF/[1]/[D]
2nd drawer feed sensor 03-[FAX]OFF/[2]/[D]
3rd drawer / tandem LCF feed sensor 03-[FAX]OFF/[3]/[D]
4th drawer feed sensor 03-[FAX]OFF/[4]/[D]
1st drawer transport sensor 03-[FAX]OFF/[1]/[C]
2nd drawer transport sensor 03-[FAX]OFF/[2]/[C]
3rd drawer / tandem LCF transport sensor 03-[FAX]OFF/[3]/[C]
4th drawer transport sensor 03-[FAX]OFF/[4]/[C]
Intermediate transport sensor 03-[FAX]OFF/[1]/[A]
Replace parts Remarks
Each sensor
LGC board
Check item Measures
To Next Page
Loading...
