e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 62
(6) Take out the drum upward.
Fig. 4-174
(7) Remove 3 screws to take off the flange on
the front side.
(8) Pull out the drum upward.
Fig. 4-175
<<Precaution when installing the drum
shaft>>
• Make sure that the gap plate is not caught
with the drum shaft.
• Be sure to install the drum shaft and
cleaner frame without a gap.
• No foreign matter must be attached on
the cleaner stay.
Fig. 4-176
Screw
Screw
Cleaner stay
Gap plate
No gap
To Next Page
Loading...
