Toshiba e-STUDIO556 - Page 212

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 66
(5) Take off the shaft of the separation finger by
sliding it to the front side.
(6) Remove 1 screw each to pull out the
separation finger [1] from the shaft.
(7) Remove 1 E-ring and 1 screw, and then take
off the separation finger [2] (in the middle)
from the shaft.
Fig. 4-186
Notes:
1. When assembling, be sure that the arm
[1] is in the hole [2] of the separation
finger.
2. Make sure you assemble the drum
separation finger with the weight screws
[1] and sttopper [3] in the correct
direction.
3. Be sure to install the separation finger in
the correct position because the shape of
the separation finger in the middle and on
the outer side is different.
Fig. 4-187
Fig. 4-188
[1]
(
1
)
(
2
)
[2]
AB
[1]
[2]
[1]
[2]
[3]
[1]
[1]
[3]