Toshiba e-STUDIO556 - Page 220

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 74
(3) Tilt the developer unit and take out the old
developer material by rotating the gear on
the rear side.
Fig. 4-209
(4) Put in the new developer material.
(5) Rotate the gear on the rear side several
times so that the developer material is mixed
evenly.
Fig. 4-210
Note:
When installing the top cover, make sure that
the latches insert completely, the cover does
not catch in the urethane seal and the
urethane sheets are overlapped correctly.
Fig. 4-211
Gear
Gear
Urethane seal
(
outside
)
Urethane seal
(
inside
)
Urethane seal