Toshiba e-STUDIO556 - Page 227

4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 81
(3) Remove 1 screw, 1 E-ring and then the
paddle bushing on the rear side.
(4) Replace the oil seal pressed into the paddle
bushing, if necessary.
* Procedure for replacing an oil seal:
( P.4-82 "4.8.18 Procedure for
replacing an oil seal")
Fig. 4-230
(5) Remove the gear, 1 E-ring and then paddle
bushing on the front side.
(6) Replace the oil seal pressed into the paddle
bushing, if necessary.
(7) Take out the paddle.
* Procedure for replacing an oil seal:
( P.4-82 "4.8.18 Procedure for
replacing an oil seal")
Fig. 4-231
Paddle bushing
Paddle bushing
Paddle