Toshiba e-STUDIO556 - Page 321

5
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
SELF-DIAGNOSTIC MODE
5 - 11
Procedure 10
Procedure 12
Procedure 14
Procedure 17
Note:
The fuser roller temperature control at the adjustment mode is different from that at the normal
state.
Therefore, the problem of fusing efficiency may be occurred in the test copy at the adjustment
mode. In that case, turn ON the power normally, leave the equipment for approx. 3 minutes after
it has become ready state and then start up the adjustment mode again.
[0][5]
[POWER]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code)
[Digital key]
(Sub code)
[START] [START][START]
[SET] or [INTERRUPT]
(Value unchangeable)
()
Value
displayed
[CANCEL]
()
[0][5]
[POWER]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code)
[Digital key]
(Adjust a value)
[START]
[START]
(Volume)
[CLEAR]
[OK]
or
[INTERRUPT]
Stores v
alue
in RAM
[CLEAR]
(Correction)
[
CANCEL
]
[0][5]
[POWER]
[POWER]
OFF/ON
(Exit)
[Digital key]
(Code)
[START]
[START]
[Digital key]
(Sub code)
[CANCEL]
(Corrects value)
[CLEAR]
(Corrects value)
[OK]
or
[INTERRUPT]
Stores value
in RAM
()
[UP]or[DOWN]
(Adjust a value)
([FAX] )
[START]
(Test copy)
()
)
[
CANCEL
] or [CLEAR]
[0][5]
[POWER]
[Digital key]
(Code)
[START]
(
Manual
adjustment
Automatic
adjustment
[POWER]
OFF/ON
(Exit)
[UP]
or
[DOWN]
(Adjust a value)
[FAX]
[START]
(Test copy)
[OK]
or
[INTERRUPT]
(Stores value)
[OK]
or
[INTERRUPT]
(Stores value)
[UP]
or
[DOWN]
(Adjust a value)
[
CANCEL
] or [CLEAR]