6
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
ADJUSTMENT
6 - 61
(6) Adjustment is completed when the transfer belt deviates neither to the front nor the rear side.
• If the transfer belt deviates towards the rear side:
The adjustment procedure is the same as that for the deviation to the front side except for the
adjustment direction of the bracket in step 3.
Example: Move the bracket somewhat to the right-hand side (drum side), and tighten the 2
screws.
Fig. 6-55
When no improvement can be seen after the adjustment, check the following items and correct if
needed.
- Check if the place of installation is flat.
- Check if the transfer/transport unit is deformed.
- Check if the transfer belt is damaged or deformed.
To Next Page
Loading...
