e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
6 - 92
(5) Open the inlet cover, and insert two sheets of paper (push them in by hand until the leading edge
of the sheets butts against the paper positioning plate).
Fig. 6-114
(6) Close the inlet door while holding it down with your hand.
(7) Press SW2 on the saddle stitcher controller PCB.
• The saddle stitcher unit will "stitch" the sheets, and fold and deliver the stack automatically.
Sheets Mark
To Next Page
Loading...
