Toshiba e-STUDIO556 - Page 558

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 50
[E550] Paper remaining jam at paper transport path
Relation between the jamming area and the corresponding sensors and covers
Classification Error item
Paper transport jam Paper is remaining on the paper transport path when the printing has
finished. (Jam caused by a multiple paper feeding)
Check item Measures
Jamming transport path Open the cover of the unit/area whose picture is flashing on the control
panel and remove any paper on the transport path.
Feed or transport roller possibly
causing multiple feeding
Check the feed roller.
Sensor in the jamming area • Sensor check (Refer to the table below)
• Harness check
• Connector check
LGC board
• Connector check
• Board check
Replace parts Remarks
Feed or transport roller possibly
causing multiple feeding
Sensor in the jamming area Refer to the table below
LGC board
Jamming area Sensor Test mode / Input check
Registration area Registration sensor 03-[FAX]ON/[4]/[E]
Exit/Reverse area Exit sensor 03-[FAX]OFF/[7]/[B]
Reverse sensor-1 03-[FAX]OFF/[7]/[E]
Reverse sensor-2 03-[FAX]OFF/[7]/[D]
Fuser transport sensor 03-[FAX]OFF/[7]/[C]
Reverse transport area Horizontal transport sensor-1 03-[FAX]OFF/[9]/[F]
Horizontal transport sensor-2 03-[FAX]OFF/[9]/[G]
Horizontal transport sensor-3 03-[FAX]OFF/[9]/[H]
Paper feeding area 1st drawer feed sensor 03-[FAX]OFF/[1]/[D]
2nd drawer feed sensor 03-[FAX]OFF/[2]/[D]
3rd drawer / tandem LCF feed sensor 03-[FAX]OFF/[3]/[D]
4th drawer feed sensor 03-[FAX]OFF/[4]/[D]
1st drawer transport sensor 03-[FAX]OFF/[1]/[C]
2nd drawer transport sensor 03-[FAX]OFF/[2]/[C]
3rd drawer / tandem LCF transport sensor 03-[FAX]OFF/[3]/[C]
4th drawer transport sensor 03-[FAX]OFF/[4]/[C]
Intermediate transport sensor 03-[FAX]OFF/[1]/[A]