e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND TROUBLESHOOTING
8 - 54
[E5A0] Paper not reaching exit sensor
[EB50] Paper remaining on the transport path due to multiple feeding
Classification Error item
Paper transport jam The leading edge of paper does not reach the exit sensor.
Check item Measures
Exit sensor
(S22)
• Sensor check (Perform the input check: 03-[FAX]OFF/[7]/[B])
• Connector check
• Harness check.
Gate Solenoid
(SOL2)
• Solenoid check (Perform the output check: 03-274)
• Connector check
• Harness check.
LGC board • Connector check (CN335)
• Board check.
Drive unit, Rollers • Gear check
• Roller check
Setting Perform 05-4536 for thick paper to increase the value by 2 to 4.
Replace parts Remarks
Exit sensor
Gate Solenoid
LGC board
Rollers
Classification Error item
Paper transport jam The multiple feeding of the preceding paper caused the misfeeding of the
upcoming paper.
Check item Measures
Registration sensor (S18) • Sensor check (Perform the input check: 03-[FAX]ON/[4]/[E])
• Connector check
• Harness check.
1st drawer transport sensor (S33) • Sensor check (Perform the input check: 03-[FAX]OFF/[1]/[C])
• Connector check
• Harness check.
LGC board • Connector check (CN341)
• Board check.
Drive unit, Rollers • Gear check
• Roller check
Replace parts Remarks
Registration sensorr
1st drawer transport sensor
LGC board
Rollers
To Next Page
Loading...
