Toshiba e-STUDIO556 - Page 671

8
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
ERROR CODE AND TROUBLESHOOTING
8 - 163
[2E45] Meta data creation error in USB storage (Scan to File)
[2E65] File creation error due to insufficient USB folder capacity
[2E66] HDD full failure during USB storage
[2EC1] Power failure in USB storage
Classification Error item
File sharing related error
Creation of meta data failed.
Check item Measures
Setting
Check the template settings. Perform the job in error again. If the error still
occurs, turn the power OFF and then back ON, and then perform the job in
error again.
Replace parts Remarks
Classification Error item
File sharing related error
Creation of a new file failed because there were too many files in the USB
folder
Check item Measures
Setting
Delete unnecessary files in the folder.
Replace parts Remarks
Classification Error item
File sharing related error
HDD became full while storing data in HDD.
Check item Measures
Setting
Delete the job in progress or being set or in the HOLD/PRIVATE/PROOF/
INVALID, and perform it again.
Check if the server or local disk has a sufficient space in disk capacity.
Check that there is enough space in the USB memory.
Replace parts Remarks
Classification Error item
File sharing related error
Power failure occurred.
Check item Measures
Setting
Check if the power cable is connected properly and inserted securely.
Check if the power voltage is unstable.