Toshiba e-STUDIO556 - Page 703

8
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
ERROR CODE AND TROUBLESHOOTING
8 - 195
[71AC] File save error during certificate acquisition from SCEP server
[71AD] Failed SCEP operation
[71B0] Software package file decryption failure
[71D0] Factory default setting failure
[71F1] Clone file creation failure
Classification Error item
Maintenance error File save error occurred during certificate acquisition from SCEP server.
Check item Measures
Setting
File saving failed for some reason. If the error still occurs after rebooting
the equipment, start up using the following procedure:[3] + [C] + [POWER]
-> 3. HDD formatting
-> Reinstallation of software or HDD replacement
Classification Error item
Maintenance error SCEP operation is failed
Check item Measures
Setting
Check SCEP server and the SCEP setting on the TopAccess menu as
follows:
[Administration] > [Security] > [Certificate Management] > SCEP
(Automatic)
Classification Error item
Maintenance error Software package file decryption failed.
Check item Measures
Setting
Software package file may have a problem or may be corrupted. Check the
software package file and then reattempt the installation.
Classification Error item
Maintenance error Factory default setting failed.
Check item Measures
Setting
Restart the equipment and then retry.
Classification Error item
Maintenance error The creation of a clone file failed.
Check item Measures
Setting
Check if there is enough capacity in the HDD and the USB media and then
retry the creation.