9
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
REPLACEMENT OF PC BOARDS / HDD
9 - 13
[D] Erase HDD
When the Data Overwrite Enabler (GP-1070) is installed, be sure to perform the following procedure
and confirm that deleting of the HDD data is completed.
(1) Turn the power ON while pressing [3] and the [C] button simultaneously.
(2) Key in [6] to select "6: Erase HDD Security." and then press the [START] button.
(3) Select "1. LOW", "2. MEDIUM", "3. HIGH" and "4. SIMPLE”.
[E] Replace / Format HDD
(1) Confirm that the power is turned OFF.
(2) Replace the HDD. ( P.9-4 "9.1.5 Hard disk (HDD)")
(3) Clear the partitions on the HDD.
1. Turn the power ON while pressing [3] and [C] button simultaneously.
2. When “Firmware Assist Mode” appears on the LCD, key in [3] to select “3: All Partition
Delete and Create Loader Partition.” and then press the [START] button.
3. When “Initialize completed.” is displayed on the LCD, clearing of the partitions is completed.
(4) Turn the power OFF.
(5) Format the service tech password.
1. Turn the power ON while pressing [3] and the [C] button simultaneously.
2. When “Firmware Assist Mode” appears on the LCD, key in [8] to select "8. Clear Service Tech
Password" and then press the [START] button.
3. When "Reset Complete" is displayed on the LCD, formatting of the service tech password is
completed.
(6) Turn the power OFF.
(7) Update the master data using the USB media.
See P.11-5 "11.2 Firmware Updating with USB Media" for details.
(8) Turn the power OFF.
(9) When the Fax Unit (GD-1250) is installed, perform “Fax Set Up” (1*-100) and “Clearing the
image data” (1*-102).Then turn the power OFF.
(10) Start up with the Setting mode (08).
(11) Check the system ROM version (08-9930).
• Confirm the version displayed on the LCD, and then press the [OK].
(12) Turn the power OFF.
To Next Page
Loading...
