Toshiba e-STUDIO556 - Page 778

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
REPLACEMENT OF PC BOARDS / HDD
9 - 24
(9) Check that the installed license is displayed on the license list.
Remark:
If there are any other licenses to be installed, repeat from step (13). If there are no other licenses
to be installed, press the [CLOSE] button, and then turn the power OFF.
[L] Enable HDD encryption
If you use the HDD encryption function, follow the procedure below.
(1) Start up with the Setting mode (08).
(2) Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [ENTER] button without entering anything.)
(3) Enable the HDD encryption function. Set the value of 08-8911 to "3", or the value of 08-8911 to
"1" and 08-9379 to "1" or "2".
(4) Turn the power OFF.
[M] Adjust image quality
(1) Start up with the Setting mode (08).
(2) Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [OK] button without entering anything.)
(3) Perform “Data transfer of characteristic value of scanner” (05-3203).
(4) Perform “Automatic gamma adjustment” <PPC> (05-7165).
 P.6-24 "6.4.1 Automatic gamma adjustment"
(5) Turn the power OFF.
[N] Initialize settings when FAX Unit (GD-1250) is installed
(1) Turn the power ON while pressing [0] and [8] simultaneously.
(2) Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [OK] button without entering anything.)
(3) Set the destination of FAX (08-9001).
(4) Turn the power OFF.
(5) Start up with the FAX Clearing Mode (1*).
(6) Perform the FAX Set Up (1*-100).
(7) Turn the power OFF and then back ON.
(8) Set the dial type according to these buttons: [USER FUNCTIONS] -> [ADMIN] -> [FAX] ->
[INITIAL SETUP]
[O] Set date and time
Set the date and time according to these buttons.
[USER FUNCTIONS] → [ADMIN] → [GENERAL] → [CLOCK] → [DATE/TIME]