e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
REPLACEMENT OF PC BOARDS / HDD
9 - 26
(4) Perform "Destination display at SRAM initialization" (08-9060).
(5) Check whether the displayed destination (see the below figure) of the SYS-SRAM board is the
same as the one in step (1).
Fig. 9-24
If the destination for the SYS-SRAM board and the one checked in step (1) is not the same,
initialize the SYS-SRAM board referring the following.
P.9-20 "9.2.6 Precautions and Procedures when replacing SRAM board"
(6) Perform "Printer all clear" (08-9090).
(7) Press [INITIALIZE] to initialize the NVRAM.
To Next Page
Loading...
