e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
FIRMWARE UPDATING
11 - 8
Fig. 11-2
• The display of items on this screen varies depending on the types of data written on the USB
media. Each item is displayed only when each data file is written on the USB media in the
following conditions.
• If the USB media are not recognized properly, “Set Correct USB Storage Device” message is
displayed. In this case, disconnect the USB media and connect it again within 3 minutes, or
shut down the equipment and connect the device properly. Then repeat the procedure from
(4).
• If any of the error messages below is displayed, confirm if the update program or the data file
in the USB media is correct. Then repeat the procedure from (4)
Item Condition
1. SYSTEM FIRMWARE (OS Data) T190SF0Wxxxx.tar is written. (xxxx is version.)
2. SYSTEM SOFTWARE (HD Data) T190HD0Wxxxx.tar is written. (xxxx is version.)
3. LASER FIRMWARE T190LWW.xxx is written. (xxx is version.)
4. PFC FIRMWARE T190FWW.xxx is written. (xxx is version.)
5. ENGINE FIRMWARE T190MWW.xxx is written. (xxx is version.)
6. SCANNER FIRMWARE T190SLGWW.xxx is written. (xxx is version.)
7. RADF FIRMWARE H190DFWW.xxx is written. (xxx is version.)
Error
number
Error message Cause
01 Error Loadmodule
Module loading failed.
02 Machine Model Get Error
Model information was not downloaded.
03 Copy Data with valid signature in USB Storage
Checking of data file failed.
04 Other models ROMDATA TXXXXXXXX
* xxxx.xxx x
Ç…ÇÕÅAÉoÅ[ÉWÉáÉìÇ™ï\é¶ÇŠÇÍÇÈÅB
Master data of other model are stored.
05 Copy Signature File in USB Storage Data files are not stored in the USB
media.
06 Patch and Normal package in one folder of
USBStorage
When both the system and patch update
packages are in the USB media.
To Next Page
Loading...
