3
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
OUTLINE OF THE MACHINE
3 - 41
→ The exit sensor (S22) detects the trailing edge of the paper.
→ The equipment enters the toner supply operation when developer material toner density is lower
than the preset value.
→ The main charger, developer bias and discharge LED (ERS) are turned OFF.
→ The drum, transfer belt, fuser unit and developer unit stop. Each fan returns to the ready rotation.
→ The feed motor (M20) is turned OFF.
→ The rotation speed of the polygonal motor (M2) switches from a high speed to a low speed.
(e-STUDIO556/656)
→ "READY" appears and the equipment enters the ready state.
To Next Page
Loading...
