Tests and Diagnostics
TECRA A11/S11/P11/Satellite Pro S500 Series Maintenance Manual (960-784) [CONFIDENTIAL] 3-11
Step 3
The next message screen is displayed.
* Re-push (NUMLOCK) key and any other key press key to continue.
Check 1: According to a message, the [NumLock] key of a ten key is pressed and then the
any other key is pressed.
Check 2 Lighting of NumLock LED of a ten key is checked. It progresses to Step 7 after this
test routine.
When the above test cannot be performed, since KB type is Un match, the Any key is pressed
and it progresses to Step 6.
Step 4
In the case of a ten-key-less keyboard, the [O] key is pressed, and then it presses the [Enter]
key.
The next message screen is displayed.
* KB type is Without 10 key...Push (Fn+f10)(K)
Check 1: Lighting of Arrow LED of F10 key lower part is checked.
Check 2: According to a message, [Fn] + [F10] Key is pushed and then the [k] key is pressed.
Step 5
The next message screen is displayed.
* Re-push (Fn +f10) key and any other key press any key to continue...
Check 1: According to a message, [Fn]+[F10] Key is pushed and then the any other key is
pressed.
Check 2: Putting out lights of Arrow LED of F10 key lower part is checked.
It progresses to Step 7 after this test routine.
When the above test cannot be performed, since KB type is Un match, the Any key is pressed
and it progresses to Step 6.
To Next Page
Loading...
