Tests and Diagnostics
3-12 [CONFIDENTIAL] TECRA A11/S11/P11/Satellite Pro S500 Series Maintenance Manual (960-784)
Step 6
The next message screen is displayed.
* KB type Un mach KB.....change KB configuration or retry
(c: change KB configuration)
(r: retry)
Check 1: The KB configuration data saved at PC is rewritten. [c}key is pushed and [Enter]
key is pushed. After rewriting data, since PC is rebooted, it carries out a test from
Step 1 again.
Check 2: When you want to test again, the [r} key is pressed and then [Enter] key is pushed.
Next, it returns to Step 1.
Step 7
The Repair test program menu starts.
Repair test program V*.**
1. DMI Entry utirity
2. Repair Heatrun (T&D)
3. Repair Main (T&D)
Enter a choice:
To start the Diagnostics menu (T&D), press 3 and Enter.
To start the H/W initial information setting tool, press 1 and Enter.
To start the Heatrun test, press 2 and Enter.
NOTE: When replacing the system board, be sure to execute the following procedures.
1. Before replacing the system board, execute subtest03 “DMI information
save” in 3.4 Setting of the hardware configuration in order to save the DMI
information from system board to floppy disk.
2. After replacing the system board, execute the subtest04 “DMI information
recovery” and subtest08 “System configuration display” in 3.4 Setting of the
hardware configuration in order to copy the DMI information and system
information from the floppy disk.
To Next Page
Loading...
Need help?
General
