TP-Link TL-SL5428E - Page 21

TL-SL5428E 24-port 10/100Mbps + 4-port Gigabit L2 Managed Switch CLI Guide
9
The following table gives detailed information about the Accessing path, Prompt of each mode and
how to exit the current mode and access the next mode.
Mode
Accessing
Path
Prompt
Logout or Access the next
mode
User EXEC
Mode
Primary mode once it is
connected with the
switch.
TP-LINK>
Use the exit command to disconnect the
switch (except that the switch is
connected through the Console port).
Use the enable command to access
Privileged EXEC mode.
Privileged
EXEC Mode
Use the enable
command to enter this
mode from User EXEC
mode.
TP-LINK#
Use the exit command to disconnect the
switch (except that the switch is
connected through the Console port).
Enter the disable command to return to
User EXEC mode.
Enter configure command to access
Global Configuration mode.
Global
Configuration
Mode
Use the configure
command to enter this
mode from Privileged
EXEC mode.
TP-LINK(config)#
Use the exit or the end command or
press Ctrl+Z to return to Privileged
EXEC mode.
Use the interface type number
command to access interface
Configuration mode.
Use the vlan database to access VLAN
Configuration mode.