TL-SL5428E
24-port 10/100Mbps + 4-port Gigabit L2 Managed Switch CLI Guide
10
Interface
Configuration
Mode
Use the interface type
number command to
enter this mode from
Global Configuration
mode.
TP-LINK(config-if
)#
Use the end command or press Ctrl+Z
to return to Privileged EXEC mode.
Enter exit command to return to Global
Configuration mode.
A port number must be specified in the
interface command.
VLAN
Configuration
Mode
Use the vlan database
command to enter this
mode from Global
Configuration mode.
TP-LINK(config-
vlan)#
Use the end command or press Ctrl+Z
to return to Privileged EXEC mode.
Enter the exit command to return to
Global configuration mode.
Note:
1. The user is automatically in User EXEC Mode after the connection between the PC and the
switch is established by a console port or by a telnet connection.
2. Each command mode has its own set of specific commands. To configure some commands,
you should access the corresponding command mode firstly.
z Global Configuration Mode: In this mode, global commands are provided, such as the
Spanning Tree, Schedule Mode and so on.
z Interface Configuration Mode: In this mode, users can configure one or several ports,
different ports corresponds to different commands
a). Interface Ethernet: Configure parameters for an Ethernet port, such as Duplex-mode,
flow control status.
b). Interface range Ethernet: The commands contained are the same as that of the
Interface Ethernet. Configure parameters for several Ethernet ports.
c). Interface link-aggregation: Configure parameters for a link-aggregation, such as
broadcast storm.
d). Interface range link-aggregation: Configure parameters for multi-trunks.
e). Interface vlan: Configure parameters for the vlan-port.
z Vlan Configuration Mode: In this mode, users can create a VLAN and add a specified
port to the VLAN.
3. Some commands are global, that means they can be performed in all modes:
z show: display all information of switch, for example: statistic information, port information,
VLAN information.
To Next Page
Loading...
