Page 12 100-11672 - Rev D
Power Supply and Power Cord
To avoid the risk of fire, electrical shock, personal injury, or damage to the
printer:
Always use the power cord provided with this printer. To avoid a fire or
electrical shock, do not use an extension cord.
Connect the printer power cord to an independent power source that is not
shared by other equipment or appliances.
Make sure that the power plug is securely and completely inserted into the
power source.
Do not cut, damage, or otherwise alter the power cord. Never place a
heavy object on the power cord, never expose it to heat, and never pull the
cord to disconnect it. If the power cord is damaged in any way
(condensation on exposed wires, broken wires, etc.) contact customer
service where you purchased the printer.
Never handle the power cord or plug when your hands are wet.
Never knot the power cord or wrap it around itself.
Disconnect the printer power cord during severe electrical storms.
Lightning could cause a fire or severe electrical shock or damage to the
printer.
To avoid a fire hazard, occasionally disconnect the power cord from the
printer and the power supply, and use a soft dry cloth to clean the cord
connectors and the connection points. Leaving the cord plugged in and not
cleaned for a long period, especially in an area subject to dust, oil, and
high humidity, could cause the insulation material to deteriorate.
Turn off the main power before removing the power plug from the outlet.
Check the power plug and cord for any problem (abnormal heat, rust,
bend, cracks, scratches, etc.) at least once a month.
If any problem is found with the power plug or cord, contact customer
service regarding a replacement cord/
Never pull on the power cord to unplug the cord from the power supply.
Always grip the plug to remove it from the power supply.
If the printer will not be used for a long period, disconnect the power cord
from the power source.
Always keep the area around the power plug free of obstacles so that you
can unplug it easily. This allows you to unplug the power cord quickly in an
emergency.
Never use any power source other than the one rated for the printer. This
printer is designed to be used in the region where you purchased. Also,
make sure that the power source can supply sufficient power for the
printer.
Supply Voltage:
AC 100-240 V, 50/60 Hz
Power Consumption:640 W (max.)
Sleep Mode :41 W
To Next Page
Loading...
