Step-by-Step Installation Instructions
Page 18 100-11672 - Rev D
Selecting the Installation Site
Installation requirements are listed below. It is recommended that the user’s
installation site be checked before delivery of the printer.
1) Power Cord of the printer must connectable to the outlet (100V - 240V AC
+10%/-15%)
Caution: There must be an easily accessible outlet near the printer.
2) The installation environment must be as described below. Avoid installing
the printer near a faucet, water heater, humidifier, or refrigerator.
Operating temperature range: 5 to 35 degrees celsius
Operating humidity range: 10%RH to 90%RH
3) Avoid installing the printer near a fire, in a dusty place, or in a place where
ammonia gas is generated. When installing the printer in a place exposed to
direct sunlight, it is recommended that curtains be hung over the window.
4) Any foot of the printer must not be floating above the floor . The printer must
be kept in a horizontal position.
5) The desk or table on which the printer is placed must be sturdy and stable
enough to support the weight of the printer.
6) Install the printer in a well-ventilated place, excluding the area near the air
inlet of the room.
7) Install the printer at least 100 mm away from each wall with a sufficient work
space around it.
To Next Page
Loading...
