TransAct Printrex 980 - Page 76

Step-by-Step Installation Instructions
Page 66 100-11672 - Rev D
3) Perform the printhead cleaning according to the table below.
Mode
Time required for
cleaning
Description
Light Cleaning
About 0.5
minutes
If an ink injection problem is detected, perform
“Light Cleaning” first. If the problem persists even
after “Light Cleaning” is performed several times,
perform “Medium Cleaning”. If the problem still
persists after “Medium Cleaning” is performed
several times, perform “Strong Cleaning”.
Medium
Cleaning
About 3 minutes
Strong Cleaning
About 7 minutes