True GDM Series User Manual

REQUIRED TOOLS
• Phillips Screwdriver
• Stiff Bristle Brush
• Adjustable Wrench
____________ STEP 1 ____________
Disconnect power to unit.
____________ STEP 2 ____________
Take off lower grill assembly by removing
four (4) corner screws.
____________ STEP 3 ____________
Remove bolts anchoring compressor
assembly to frame rails and carefully slide
out. (tube connections are flexible)
____________ STEP 4 ____________
Clean off accumulated dirt from condensing
coil with a stiff bristle brush.
____________ STEP 5 ____________
Lift cardboard cover above fan at plastic
plugs and carefully clean condenser coil
and fan blades.
____________ STEP 6 ____________
After brushing condenser coil vacuum dirt
from coil, and interior floor.
____________ STEP 7 ____________
Replace cardboard cover. Carefully slide
compressor assembly back into position
and replace bolts. When reinstalling
condensing unit becareful not to crimp
or damage the tubing between the con-
densing unit and the cabinet.
____________ STEP 8 ____________
Reinstall louver assembly onto unit with
appropriate fastener and clips. Tighten all
screws.
____________ STEP 9 ____________
Connect unit to power and check to see if
compressor is running.
Step 4
Step 6
GENERAL MAINTENANCE
CONDENSER CLEANING
18

True GDM Series Specifications

General

Defrost Type	Automatic
Weight	Varies by model
Shelves	Adjustable Wire Shelves
Lighting	LED
Interior Finish	Stainless Steel
Compressor Location	Bottom
Energy Efficiency	Energy Star Certified
Capacity	Varies by model
Dimensions	Varies by model