True GDM Series User Manual

78
REQUIRED TOOLS
• Drill With 1/8" Bit
• Phillips Head Screwdriver
__________ STEP 1 __________
Remove left side door by lifting up
and out of bottom track.
__________ STEP 2 __________
Position the plastic door stop cen-
tered in the front door channel and
mark it. Center within the confines
of the door that was removed.
__________ STEP 3 __________
Peel backing from double-sided
tape and position on previously
marked spot.
__________ STEP 4 __________
Drill 1/8" holes using the pre-
drilled holes of the plastic door stop
as a template.
__________ STEP 5 __________
Install phillips counter-sunk screws
provided. (see figure 3.)
__________ STEP 6 __________
Replace left side door and check
slide operation. If door stop
impedes closing of left hand door,
remove door, detach plastic door
stop and remove one layer or piece
of the door stop and reinstall.
NOTE:
Length of door stop and
number of screws determined
by cooler model
Figure 3
Plastic Door Stop Installation Instruction
(Unnecessary if factory installed)
INSTALLATION INSTRUCTION
RATCHET LOCK & PLASTIC DOOR STOP - SLIDE DOOR ...Continued

True GDM Series Specifications

General

Defrost Type	Automatic
Weight	Varies by model
Shelves	Adjustable Wire Shelves
Lighting	LED
Interior Finish	Stainless Steel
Compressor Location	Bottom
Energy Efficiency	Energy Star Certified
Capacity	Varies by model
Dimensions	Varies by model