30
TOP REMOVAL FOR TD & T-GC UNITS
Lid
Trunion
Top Screws
TOP REMOVAL FOR TD & T-GC UNITS
1. Turn unit off and remove lids.
2. Remove screws along back of cabinet top.
3. Remove screws on each side, going through lid slide rails, inside cooler.
4. Remove screws along front of top under inside ledge, also remove the two screws holding center trunion
on units with more than one door.
5. Lift top to approximately 45 degrees while pushing top forward at same time. Top will lift off lip in front.
T-50-GC has heater wire looped through center trunion. Please becareful when removing top. Before
reinstalling, inspect heater wire to make sure it is not damaged.
6. To reinstall top, while holding top at 45 degree angle hook top on lip at front of cabinet and lay down while
pushing backwards on top, when laid completely down press firmly on top to provide a good seal.
7. Reinstall all screws along inside of cabinet and along back of top on outside of cabinet.
8. Reinstall doors and turn unit on.
To Next Page
Loading...
Need help?
General
