8
INSTALLATION INSTRUCTION
CABINET INSTALLATION AND SET-UP (SWING & SLIDE DOORS)
SWING DOORS
A. Remove all other tape securing
the doors to the cooler. Remove
the blue foam blocks approximate-
ly 1”x3”x1” (2.5 x 7.6 x 2.5 cm)
that are between the door and the
cooler. One foam block is located
on each side of the door frame. (left
and right).
NOTE
Your True Merchandiser has been
secured for safe shipping. During
installation, it is necessary to remove
the door support bracket.
B. Remove the two phillips screws
that secure the bracket to the door.
(see figure 1).
C. Remove bracket and save for
future shipping.
D. Replace screws securely into door.
SLIDE DOORS
A. Remove all transparent tape on the
door area. Remove the foam blocks in
top channel in front on the right door
approximately 1”x1”x20” (2.5 x 2.5 x
50 cm).
B . Remove both plastic brackets
secured by tape from under the left
door.
C. Open the left door.
D. Remove the foam block from the
top channel behind the left door.
E. Remove both plastic brackets from
under the right door (see figure 2).
NOTE
Door packing materials should NOT
be removed until cooler is placed on
location.
TRANSPORTATION OF THE
COOLER WITHOUT THE DOOR
PACKING MATERIALS IN
PLACE CAN RESULT IN DAM-
AGE TO DOORS, DOOR
ROLLERS AND V-TRACK
(figure 1)
(figure 2)
To Next Page
Loading...
Need help?
General
