True GDM Series User Manual

This instruction is True's
recommended procedure for
installing a remote CO
2
container.
REQUIRED TOOLS
• Pliers
• Power Drill
• Silicone sealer
• Drill bit,
1/2”
__________ STEP 1 __________
Remove black knockout plug with
a pair of pliers.
__________ STEP 2 __________
Use drill to bore hole through insu-
lation while holding tool at a 30°
angle, this should line up with a
pre-punched hole in the compressor
compartment.
__________ STEP 3 __________
Snake CO
2
line through knockout
hole and newly drilled hole and
route through rear grill louvers.
__________ STEP 4 __________
Seal hole around CO
2
line with sil-
icone sealer to prevent cold air
leakage.
91
INSTALLATION INSTRUCTION
TDD-2,3,4 (and Club Top models) CO
2
Knock-out

True GDM Series Specifications

General

Defrost Type	Automatic
Weight	Varies by model
Shelves	Adjustable Wire Shelves
Lighting	LED
Interior Finish	Stainless Steel
Compressor Location	Bottom
Energy Efficiency	Energy Star Certified
Capacity	Varies by model
Dimensions	Varies by model