True GDM Series User Manual

55
REQUIRED TOOLS
• Phillips Head Screwdriver
• 3⁄8" Wide Double-Sided Tape
___________ STEP 1 ___________
Slide left door (door positioned on out-
side track) to the right. Lift door up
and pull out at the bottom. Right door
(door positioned on inside track) can
be removed in the same manner.
___________ STEP 2 ___________
Remove the nylon cord from the top of
the door.
___________ STEP 3 ___________
Set the door (handle side down) on a
flat surface.
___________ STEP 4 ___________
Remove the screws that secure the four
glass insert holders to the door.
Remove all four aluminum pieces.
___________ STEP 5 ___________
Beginning at the corners carefully pry
the broken glass loose from the frame.
If necessary use heat gun or hair dryer
aimed in the space between glass insert
and door frame to lessen adhesion of
double-sided tape. Carefully dispose
of the damaged glass.
___________ STEP 6 ___________
Remove any excess tape or glass from
the lip on the door frame. Replace with
new double-sided tape on the 1⁄2" lip.
___________ STEP 7 ___________
Remembering to keep the tempered
glass to the handle side of the frame
place the new glass insert inside the
frame and press against the two-way
tape. (The etched TRUE logo is posi-
tioned on the tempered glass side.)
___________ STEP 8 ___________
Replace the four Aluminum glass
insert holders.
___________ STEP 9 ___________
Reconnect the nylon cord to the top of
the door and replace the door as origi-
nally removed.
GDM-45
INSTALLATION INSTRUCTION
GLASS INSERT - SLIDE DOOR

True GDM Series Specifications

General

Defrost Type	Automatic
Weight	Varies by model
Shelves	Adjustable Wire Shelves
Lighting	LED
Interior Finish	Stainless Steel
Compressor Location	Bottom
Energy Efficiency	Energy Star Certified
Capacity	Varies by model
Dimensions	Varies by model