Unipulse F320 - Default Chapter; Table of Contents

CONTENTS
CONTENTS
1．FUNCTIONAL DESCRIPTIONS .............................................1
1-1．Front Panel ............................................................................................ 1
1-1-1Status Display ..................................................................................... 1
1-1-2Numerical Display ............................................................................... 2
1-1-3Setting Key Pad ................................................................................... 3
1-2．Rear Panel ............................................................................................. 5
1-2-1Protective Ground ............................................................................... 5
1-2-2Frame Ground (Frame terminal) ........................................................ 5
1-2-3Options Slot ......................................................................................... 5
1-2-4AC Power Input Terminal Block ........................................................ 6
1-2-5Signal Input/Output Terminal Block .................................................. 6
2． INSTALLING IN A CONTROL PANEL ....................................8
3．CONNECTION ........................................................................9
3-1．Connecting Strain Gauge Sensor ..................................................... 10
3-2．Connecting Power Input Terminal .................................................... 12
3-2-1AC Spec. ............................................................................................ 12
3-2-2DC Spec. ( Depending on the request at the time of order ) ......... 15
3-3．Connecting High / Low Limit Relays ................................................. 18
3-4．Connecting Hold and Digital Zero Signals ....................................... 19
3-5．Connecting Analog monitor Output (VOL OUT) .............................. 20
4．SETTING MODE CONFIGURATION ....................................21
4-1．Selection of Setting Items .................................................................. 21
4-2．Display of Setting Items ..................................................................... 23
4-3．List of Values ...................................................................................... 25
4-4．Setting Procedure ............................................................................... 28