14.SELF-CHECK FUNCTION AND INITIALIZATION
103
14-2. Initialization
The Initialization is an operation to reset the memory to the factory setting. This
operation resets all set values except calibrated values （obtained through zero
calibration and span calibration） to the factory setting
The initialization follows the self-check.
1）Turn off the power to the F320.
2）Turn on the power with and keys held down.
• For the initialized values, see the “List of Values” on page 25.
• If self-check is not needed, initialization can also be performed
by inputting the password.
For details, see “Password” on page 99.
To Next Page
