Unipulse F320 - Equivalent Input Calibration Procedure

5.CALIBRATION
30
5-1. Equivalent Input Calibration Procedure
The equivalent input calibration uses the following procedure :
Release the Calibration LOCK that inhibits
calibration.
Set the decimal place.
（omissible if no desired value is present）
Set the minimum value of the digital change
desired
（omissible if no desired value is present）
Set the rated output vale and zero point of the
strain gauge sensor.
Set the calibration of ON to prevent misopera-
tion.
Releasing Calibration LOCK
Setting Decimal Place
Equivalent Input Calibration
Calibration Lock
Setting Scale Division