Uponor Smatrix Wave PULSE - Install Room Controller Antenna

Using screws and wall plugs
110 mm
80 mm
SI0000009
Attach the room controller to the wall using screws and wall plugs.
5.4 Install room controller antenna
CD0000002
Caution!
If the room controller is installed inside a metal cabinet,
the entire antenna must be placed outside the cabinet.
Caution!
The antenna must be installed vertically for best
coverage.
The antenna can be attached to any surface using adhesive tape.
1. Attach antenna with adhesive tape
SI0000161
Caution!
The antenna must be installed vertically for best
coverage.
Attach the antenna to the wall using double sided adhesive tape.
2. Connect the antenna cable
SI0000004
Connect the antenna to the room controller.
Uponor Smatrix Wave PULSE
|
Installation and operation manual
|
23