Uponor Smatrix Wave PULSE User Manual

14.7 Replace batteries
Uponor Smatrix Wave T-161
Replace the battery of the thermostat when the LED flashes (once
every two hours).
The thermostat will perform a self test, for about 10 seconds, when
the battery have been inserted. The system will be blocked for input
and the thermostat LED flashes during this period.
3
1
2
SI0000189
To change the battery:
1. Remove the thermostat from the wall.
2. Use a pointed object to remove the battery.
3. Replace the battery.
Uponor Smatrix Wave T-163/T-165
Replace the batteries of the thermostat when the LED flashes twice
during a heating or cooling demand.
The thermostat will perform a self test, for about 10 seconds, when
the batteries have been inserted. The system will be blocked for input
and the thermostat LED flashes during this period.
SI0000190
3
1
2
To change the batteries:
1. Angle the thermostat from the bracket.
2. Remove it from the wall.
3. Replace the batteries.
Uponor Smatrix Wave T-166/T-168
Replace the batteries of the thermostat when the low battery icon is
shown in the display.
SI0000191
3
1
2
To change the batteries:
1. Angle the thermostat from the bracket.
2. Remove it from the wall.
3. Replace the batteries.
Uponor Smatrix Wave T-169
Replace the battery of the thermostat when the low battery icon is
shown in the display (alarm list).
3
1
2
SI0000192
To change the battery:
1. Remove the thermostat from the wall.
2. Use a pointed object to remove the battery.
3. Replace the battery.
14.8 Factory reset
Note
Do not factory reset the thermostat if not absolutely
needed.
Note
A factory reset removes the registration data from the
thermostat.
Factory reset sets all parameter values to default settings.
Uponor Smatrix Wave PULSE
|
Installation and operation manual
|
95

Uponor Smatrix Wave PULSE Specifications

General

Brand	Uponor
Model	Smatrix Wave PULSE
Category	Temperature Controller
Language	English