Uponor Smatrix Wave PULSE User Manual

7. Set year
SI0000102
Use buttons - or + to change the value, press the OK button to set the
value and move to the next editable value.
14.4 Adjust temterature
The temperature is changed by adjusting the setpoint on the
thermostat to a value between 5 and 35 ˚C. It is possible to set
minimum and maximum temperature limits using the Uponor Smatrix
PULSE app (requires communication module).
Uponor Smatrix Wave T-161
The setpoint for the thermostat can only be changed via the Uponor
Smatrix PULSE app (requires communication module). Otherwise the
setpoint will be fixed to 21 ˚C.
Uponor Smatrix Wave T-163
To change the thermostat temperature setpoint:
20
5
35
1
2
3
SI0000181
1. Angle the thermostat from the bracket.
2. Remove it from the wall.
3. Set the desired temperature using the potentiometer.
4. Put the thermostat back on the wall.
Uponor Smatrix Wave T-165
Use the dial on the thermostat to adjust the temperature. A backlight
will light up when twisting the dial. It shuts off after about 10 seconds
of inactivity.
SI0000182
To adjust the thermostat temperature setpoint:
• Twist the dial clockwise for a higher temperature.
• Twist the dial counter-clockwise for a lower temperature.
Uponor Smatrix Wave T-166
Use the buttons on the thermostat to adjust the temperature. The
display will light up when pushing a button. It shuts off after about 10
seconds of inactivity.
SI0000183
CD0000097
To adjust the thermostat temperature setpoint of the current control
mode:
1. Press the - or + button once.
The screen shows the current setpoint flashing.
2. Press the - or + button repeatedly to adjust the setpoint
temperature. It will change with increments of 0.5.
When the new setpoint is set, the screen returns to run mode
after a few seconds, showing the room temperature.
Uponor Smatrix Wave T-168
Use the buttons on the thermostat to adjust the temperature. The
display will light up when pushing a button. It shuts off after about 10
seconds of inactivity.
SI0000183
CD0000098
To adjust the thermostat temperature setpoint of the current control
mode:
1. Press the - or + button once.
The screen shows the current setpoint flashing.
2. Press the - or + button repeatedly to adjust the setpoint
temperature. It will change with increments of 0.5.
When the new setpoint is set, the screen returns to run mode
after a few seconds, showing the room temperature.
88
|
Uponor Smatrix Wave PULSE
|
Installation and operation manual

Uponor Smatrix Wave PULSE Specifications

General

Type	Wireless Temperature Controller
Communication Protocol	RF (Radio Frequency)
Compatibility	Uponor Smatrix Wave system
Operating Temperature Range	0°C to 50°C
Display	LCD
Control	Wireless