Uponor Smatrix Wave PULSE User Manual

T-169
CD0000015
Current software version is displayed during power up.
Set time and date (T-168 only)
CD0000006
Note
If no button on the thermostat is pressed for about
8 seconds, while in a submenu, the current values will be
saved and the software exits to the settings menu. About
about 60 seconds later, it exits to run mode.
At first startup, after a factory reset, or after its been left without
batteries too long, the software requires the time and date to be set.
This setting is required to utilise scheduling programs for this
thermostat.
Use buttons - or + to change the value, press the OK button to set the
value and move to the next editable value.
Date and time can also be set later in the settings menu.
1. Set hours
SI0000096
Use buttons - or + to change the value, press the OK button to set the
value and move to the next editable value.
2. Set minutes
SI0000097
Use buttons - or + to change the value, press the OK button to set the
value and move to the next editable value.
3. Set 12H/24H time format
SI0000098
Set 12h or 24h time format.
Use buttons - or + to change the value, press the OK button to set the
value and move to the next editable value.
4. Set weekday
SI0000099
Set weekday (1 = Monday, 7 = Sunday).
Use buttons - or + to change the value, press the OK button to set the
value and move to the next editable value.
5. Set day of the month
SI0000100
Use buttons - or + to change the value, press the OK button to set the
value and move to the next editable value.
6. Set month
SI0000101
Use buttons
- or + to change the value, press the OK button to set the
value and move to the next editable value.
Uponor Smatrix Wave PULSE
|
Installation and operation manual
|
87

Uponor Smatrix Wave PULSE Specifications

General

Type	Wireless Temperature Controller
Communication Protocol	RF (Radio Frequency)
Compatibility	Uponor Smatrix Wave system
Operating Temperature Range	0°C to 50°C
Display	LCD
Control	Wireless