Uponor Smatrix Wave PULSE User Manual

2 Preface
This installation and operation manual describes how to install and
operate the components of the system.
2.1 Safety instructions
Warnings used in this manual
The following symbols are used in Uponor ducumentation to indicate
special precautions when installing andoperating any Uponor
equipment:
Warning!
Risk of injury. Ignoring warnings can cause injury or
damage components.
Caution!
Ignoring cautions can cause malfunctions.
Note
Important information to the section in the manual.
Safety measures
Conform to the following measures when installing and operating any
Uponor equipment:
• Read and follow the instructions in the installation and operation
manual.
• Installation must be performed by a competent person in
accordance with local regulations.
• It is prohibited to make changes or modifications not specified in
this manual.
• All power supplies must be switched off before starting any
wiring work.
• Do not use water to clean Uponor components.
• Do not expose the Uponor components to flammable vapours or
gases.
Uponor cannot accept any responsibility for damage or breakdown
that can result from ignoring these instructions.
Power
Warning!
The Uponor system uses 50 Hz, 230 V AC power. In
case of emergency, immediately disconnect the power.
Technical constraints
Caution!
To avoid interference, keep installation/data cables away
from power cables of more than 50 V.
2.2 Limitations for radio
transmission
Wireless Uponor products uses radio transmission for
communication. The frequency used is reserved for similar
applications, and the chances of interference from other radio
sources are very low.
However, in some rare cases, it might not be possible to establish
perfect radio communication. The transmission range is sufficient for
most applications, but each building has different obstacles affecting
radio communication and maximum transmission distance. If
communication difficulties exist, Uponor recommends relocating the
antenna to a more optimal position, and not installing Uponor radio
sources to close to each other (at least 40 cm apart), for solving
exceptional problems.
2.3 Correct disposal of this
product (Waste Electrical and
Electronic Equipment)
Note
Applicable in the European Union and other European
countries with separate collection systems
This marking shown on the product or its literature indicates
that it should not be disposed with other household wasted at the end
of its working life. To prevent possible harm to the environment or
human health from uncontrolled waste disposal, please separate this
from other types of wastes and recycle it responsibly to promote the
sustainable reuse of material resources.
Household users should contact either the retailer where they
purchased this product, or their local government office, for details of
where and how they can take this item for environmentally safe
recycling.
Business users should contact their supplier and check the terms and
conditions of the purchase contract. This product should not be mixed
with other commercial wastes of disposal.
Uponor Smatrix Wave PULSE
|
Installation and operation manual
|
5

Uponor Smatrix Wave PULSE Specifications

General

Type	Wireless Temperature Controller
Communication Protocol	RF (Radio Frequency)
Compatibility	Uponor Smatrix Wave system
Operating Temperature Range	0°C to 50°C
Display	LCD
Control	Wireless