System Menu
6-6 ADVANCED OPERATION GUIDE
Original/Paper Setup
Register additional types and sizes of originals and paper.
Custom Original Size Setup
Set up frequently-used custom original sizes. The custom size options are
displayed on the screen to select original size. The dimensions available
are as follows.
The table below lists the sizes that can be registered.
Up to four custom original sizes can be added. Use the procedure below
to select the interface.
1
Press the System Menu key.
2
Press [Common Settings], [Next] of Original / Paper Setup and then [Next]
of Custom Original Size.
3
Press [Change] of any one of Custom 1 to Custom 4, on which you wish to
register the size.
4
Press [On], and then
press [+]/[–] or
numeric keys to
enter X(horizontal)
and Y (vertical)
dimensions.
5
Press [OK].
Adding a Custom Size and Media Type for Paper to Print
Set up a maximum of four frequently-used custom paper sizes. The
custom size options are displayed on the screen to select paper set in the
Multi Purpose tray.
Input units Dimensions
Inch models X: 2 to 17" (in 0.01" increments)
Y: 2 to 11.69" (in 0.01" increments)
Metric models X: 50 to 432 mm (in 1 mm increments)
Y: 50 to 297 mm (in 1 mm increments)
Common Settings - Custom 1
Register a custom original size .
On
X(2. 00 - 17.00)
17.00
Off
Cancel OK
Status 10/10/2007 10:10
# Keys
Y(2.00 - 11.69)
11.69
# Keys
Paper is remaining in Document Processor.
"
"
To Next Page
Loading...
Need help?
General
