MC122 - MCP-4J Control Unit Section 4 - Programming
57
Restore
USB
If there is no USB flash drive inserted into the USB, it will show “No Device”. If pressing “Load” while no USB flash
drive is inserted, the control will display:
If a USB flash drive is inserted, but has no backup saved to it, it will show “No Backup”. If pressing “Load” while no
USB flash drive is inserted, the control will display:
If a USB flash drive is inserted, and has a valid backup saved to it, it will show “Backup Exists”. Pressing “Load” will
prompt the user with the following message:
X2
X4
To Next Page
Loading...