MC122 - MCP-4J Control Unit Section 5 - Operation
83
Load a Job - Continued
When the desired job number has been entered, press the Right Arrow Button to highlight “OK” and press the OK
Button. The job is loaded.
Enter the job number and information in a chart (see
Appendix A - Job Charts) for quick job set up. Also, jobs can
be overwritten, so it is important to keep track of them.
Save a Job
Only password levels 2 or higher can save a job.
Save - Save all settings under a job number.
Press the Right Arrow Button to highlight “Save” and then press the OK Button.
Use the Plus/Minus Buttons to change the job number.
To Next Page
Loading...
Need help?
General